11.2 Configuring the Local Setting

By default, the Endpoint Security Agent is configured to use the Agent Security setting configured in ZENworks Control Center. However, the Endpoint Security Agent also provides a local setting that you can use to enable or disable self defense. This local setting overrides the agent self defense setting configured in ZENworks Control Center.

  1. Make sure you have enabled the device to accept an override password. For information, see Section A.0, Override Password.

  2. On the device, double-click the icon in the notification area, then click Endpoint Security.

  3. In the Endpoint Security Agent Actions section, click About to display the About dialog box.

  4. Click Settings.

  5. In the Agent Self Defense section, select from the following settings:

    Enabled: Enables Client Self Defense.

    Disabled: Disables Client Self Defense.

    Policy: Uses the agent self defense setting configured in ZENworks Control Center.

  6. Click Set.

  7. Click Close to exit the dialog box.