E.7 ZENworks Partition Mode (img zenPartition)

Use the ZENPartition mode to enable, disable, or remove the installed ZENworks partition.

  1. Do one of the following:

    • From the bash prompt, enter the following:

      img zenPartition operation

      where operation is enable, disable, or remove.

    • Enter img to display the ZENworks Imaging Engine menu, click Partitioning, then click one of the following:

      Disable ZENworks partition

      Enable ZENworks partition

      Remove ZENworks partition

  2. Enter lilo.s to make this change effective.

IMPORTANT:If you remove an installed ZENworks partition, you must immediately restore a base image with a valid non-LILO MBR (Master Boot Record). If you do not, the device cannot boot properly.