Configuring TCP/IP

You must have TCP/IP bound and configured to install the Novell BorderManager 3.7 software. You can download the most recent version of TCPIP.NLM from the Novell Technical Support Web site. There are currently three versions of the TCPIP.NLM:

• A version for NetWare servers without Novell BorderManager 3.7 installed
• A version for NetWare servers with the 40-bit encryption version of Novell BorderManager 3.7 installed
• A version for NetWare servers with the 128-bit encryption version of Novell BorderManager 3.7 installed

Make sure you get the appropriate version required for the server on which you will be installing TCP/IP.

To verify that TCP/IP is configured on your server, complete the following steps:

1. At the server console prompt, enter

   CONFIG

2. Review the list for TCP/IP protocol configuration.

   If TCP/IP is not configured, continue with Configuring TCP/IP.

Loading TCP/IP

To load TCP/IP:

1. At the NetWare server console prompt, enter

   LOAD INETCFG

2. To transfer the LAN driver, protocol, and remote access commands, select Yes.

3. From the Internetworking Configuration menu, select Protocols > TCP/IP.

4. Highlight TCP/IP Status > press Enter.

5. Select Enabled > press Enter.

6. To return to the Internetworking Configuration menu, press Esc twice.

7. From the Internetworking Configuration menu, select Bindings.

8. Press Ins > select TCP/IP.

9. From the list of configured network interfaces, select the network board to which TCP/IP will bind.

10. Enter your local IP address and subnet mask.

11. To update the TCP/IP configuration, press Esc > select Yes.

12. To reinitialize the system, enter the following at the server console:

    REINITIALIZE SYSTEM

13. To verify that TCP/IP is configured successfully, enter the following at the server console:

    CONFIG