Problem:
Users are logged out at incorrect times or time restrictions are shown incorrectly or LASTLOGIN displays an incorrect time.
Possible Cause:
The time zone is not set correctly.
Action:
Use one of the following commands to set the time zone:
Problem:
The NetWare® server reports the following error:
Synthetic time is being issued on partition.
Possible Cause:
In NetWare 4 and later versions, synthetic time is issued at a server with the error DS- 4.63-12 if the server time is set backwards. The synthetic time is cycled every two minutes until the server time is later than the last modified time stamp.
Action:
Run DSREPAIR.
Click Advanced Options > Replica and Partition Operations, and then select the partition you want to update.
Timesync in a Forced Scenario
Problem:
Timesync in a forced scenario might not work in some setups.
Action:
To resolve this, do the following:
-
Set Timesync Configured Sources = ON
-
Specify the IP address, DNS name, or file server name of the time source in the Timesync Time Sources parameter.
Time Synchronization Fails on a NetWare 6.5 Server if it is Installed as a Secondary Time Server in a NetWare 4.x Tree
Problem:
If you try to install a NetWare 6.5 server as a secondary time server (with default configuration) into a NetWare 4.x tree, time synchronization will fail on the NetWare 6.5 server.
Action:
To resolve this, do the following:
-
Give the file server the name of NetWare 4.x server in Timesync Time Sources without:123
-
Set Timesync Configured Sources = ON
Problem:
The Monitor screen hangs for a minute.
Possible Cause:
An invalid IP address is given as the time source and the RESET flag is pressed.
Action:
Give a valid IP address and proceed.