Source:  NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN

Possible Cause:  The network board is not present in the computer, or the network board's configuration cannot be obtained.

Action:  Do one of the following:

• Make sure the network board is properly seated into the slot.
• Insert the network board into a slot, and run the Reference diskette to install it.

Possible Cause:  The network board settings are not the defaults, and they are not defined in the AUTOEXEC.NCF file.

Action:  If jumper settings are not the defaults, make sure they match the settings in the AUTOEXEC.NCF file. If the computer is not using the AUTOEXEC.NCF file, make sure the jumper settings are set to the defaults.

Possible Cause:  Another network board is using the same hardware settings as this network board.

Action:  If other network boards are using the same hardware settings, change the settings and try to reload the driver.

Possible Cause:  The network board is faulty.

Action:  Replace the bad network board.