24.2 Migrating FTP to OES 2018 SP2

This section describes how to migrate FTP from a supported OES environment to OES 2018 SP2.

Before you proceed with the migration, review Prerequisites. In this section, the source server refers to a supported OES server and the target server refers to an OES 2018 SP2 server.

24.2.1 Prerequisites

Ensure that OES 2018 SP2 server is already installed along with the FTP pattern on the target server. For details see, Installing Pure-FTPd in the OES 2018 SP2: Planning and Implementation Guide.

24.2.2 What is Migrated

Configuration file and script

24.2.3 Migration Procedure

Same tree migrations with identity transfer

Perform the following procedures on the target server:

Copy the /etc/pure-ftpd/pure-ftpd.conf file from the source server.

NOTE:If the migration is being performed on a cluster setup, copy the pure-ftpd.conf file on the shared volume of cluster.
Run /opt/novell/pure-ftpd/novell-pure-ftpd-config.sh script. This will update the pure-ftpd.conf file with the new parameters added in OES2015 or later.
Remove LD_PRELOAD statement from the /usr/lib/systemd/system/pure-ftpd.service file, if present.
Restart pure-ftpd using the systemctl restart pure-ftpd.service command.

Same tree migrations without identity transfer

Execute steps Step 1 to Step 3.
Update the IP address of the target server for ForcePassiveIP and Bind parameters in the pure-ftpd.conf file.
Update DefaultHomeDirectoryServer if it refers to the IP of the source server.