If the ZENworks Virtual Appliance 11 SP2 server that you upgraded to ZENworks Virtual Appliance 11 SP3 is configured to use a dynamic IP address, you must manually update the DHCP configuration for the new server before you start using it. This is to ensure that it takes on the network identity of the ZENworks Virtual Appliance SP2 server.
Verify the ZENworks Services by following the steps provided in Verify That ZENworks 11 SP3 Services Are Running.
Verify the ZENworks database and Audit database by following the steps provided in, Running ZDC
in ZENworks 11 SP3 Command Line Utilities Reference
.
If you want to add more hard disk space to your new Virtual Appliance 11 SP3, then follow the steps provided in Post-Deployment Tasks
in ZENworks Virtual Appliance 11 SP3 Deployment and Administration Reference.
Check the Linux services by using the specific service commands
On the server, run the following commands:
/etc/init.d/novell-zenserver status
/etc/init.d/novell-zenloader status
If the services are not running, run the following commands to start the ZENworks services:
/etc/init.d/novell-zenserver start
/etc/init.d/novell-zenloader start
Check the Linux services by using the configuration command
On the server, run the following commands:
/opt/novell/zenworks/bin/novell-zenworks-configure ‑c SystemStatus
This lists all ZENworks services and their statuses.
To start the services, run the following command:
/opt/novell/zenworks/bin/novell-zenworks-configure ‑c Start
Run ZENworks Control Center
Use the following URL to open the ZENworks Control Center in a web browser on any device in your network:
https://DNS_name_or_IP_address_of_Primary_Server/zenworks